ESPER eVF1 - Long Barrel Version

thingiverse

Edit 09/13/19: Remembered to upload my shortened version. The long section of super thin material wasn't doing any favors so I ditched it entirely. This one works great for long barrels without the extra drag and chance of breaking off. Edit 06/28/19: Figured out why it broke, when I bored it out I used an 8mm radius instead of the 8.128mm it already has a section of, so there was a good bit more friction on it than there should have been. I'll be printing a new one over the weekend and see how that fits. Oh, and I rotated it to print orientation, took me a bit to figure out how. Edit 06/23/19: After kit assembly I discovered that the "hollowing out" of this piece leaves it pretty fragile around the decorative cutouts and it's too easy to break a few of them if your barrel is a bit of a tight fit in the piece. I'll work on a version with either a slightly bigger ID or those cutouts filled in. Took the eVF1 part of the ESPER Foregrip Kit and extruded the center out to fit a longer-than-stock barrel. Otherwise it's the same. Might need to be rotated 180 degrees to print.