eSun (52mm) Spool Adapter for Ender 3 Pro Spool Holder

thingiverse

This adapter fits on the factory spool holder for the Ender 3 Pro. It centers the spool on the factory holder and allows it to rotate uniformly around its center. ###BACKGROUND This particular factory spool holder was a pain to work with because of the molded rings on either end that I suppose are intended to keep spools with a smaller inner diameter on the rod. These prevented me from just adding a 30mm ID/52mm OD cylinder like I did on my CR-10S. I would have needed to make the ID big enough to slip over the molded rings and then the center of the cylinder would still be off-center. I brainstormed a few ideas and settled on assembling the adapter in place, using a threaded nut. I'm pleased with how it turned out! Everything fits closely, but not tight. ###ASSEMBLY Spools don't move laterally very much during printing, but I made the adapter about as wide as I could so that if the spool does shift, it doesn't fall off. This was much simpler than dealing with threads and nuts on both ends, "fun" as that might have been. The consequence of this decision is that it's a tight fit on the stock rod. You have to assemble the adapter on the rod and then attach the rod to the arm in reverse of how you might have done it stock. The assembly steps are: 1. Put the two pieces on the rod and line up the threads. 2. Screw on the nut. The adapter is now secured on the rod. 3. Insert the grooved end of the rod into the arm from the FLAT side, not the recessed side. 4. Secure the rod with the factory nut. 5. Secure arm to printer. I'm using one of the side spool mounts and I like it a lot. ##OTHER IMPORTANT NOTES 1. I needed to print the nut at 102% for the right fit! 2. I messed up when I printed this and left the z-seams on the sides with the threads. Thankfully the threads still work great! I recommend you adjust the seam so that it ends up inside the cylinder. 3. I printed this with a 1mm nozzle because I am impatient and much of the model is just a simple cylinder. Using two processes in Simplify3D, I printed the thread layers (0-8mm) at .25mm and the rest at .5mm layer height. I printed the nut the same way, at .25mm.