Eurorack Synth Stand - Pittsburgh Modular SV-1

thingiverse

This is a stand for a Pittsburgh Modular SV-1 synthesizer black box edition. To print the other side, just mirror the file in your slicer. The wooden base is 20cm x 16cm. This allows the rubber feet on the back of the SV-1 to hold the synth in place. You can also add little rubber stick on pads that are available in any hardware store. I left roughly 3mm play on both axis to accommodate an sort of padding or shims you may want to add, but it works just fine without. The washers the screws are set into are called cup washers, or countersunk finishing washers. They are #10 size.