EV800 Glasses Mod

thingiverse

This is a modified back half of the Eachine EV800 and EV800D goggles to make room for glasses. So far this has fit both my EV800's and my buddies EV800D's. You will need to disassemble the back half of your goggles and use the fresnel lens and the screws from the original. You will need to modify your original foam to fit this and possibly come up with your own foam solution. The top strap will now be held on by a 35mm standoff and 2 m3 bolts, or just run a screw through the two top pegs, depending on what you have at hand. I found it prints best with the bottom piece's bottom flat to the printbed, and for the top section to be vertical with the flat section against the printbed. It takes a decent amount of filament so be sure you have a good bit still on your roll. I will try and revise this as needed, I'm sure there are some changes that will make it more functional.