Everblock 2X2 cap, with name, cut in half
thingiverse
This is an end cap for my little friend who loves to play princess. I created her a throne using the EverBlock starter kit and had some leftover material. So, I made these covers to finish off the edges. Initially, I tried printing a full cover but didn't have enough space on my printer. Therefore, I trimmed it down by an inch on both sides, flipped it 45 degrees to fit. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator 2 Rafts: Yes Supports: No Resolution: 0.02 Infill: 20% Notes: Using rafts is highly recommended; it works without them but leaves a rough surface underneath. After printing, I applied the smooth finish last. Princess P in her cozy throne How I Designed This I used Autodesk's free software, 123D Design to create this part. It was all about basic geometry and measurements, with a 0.05 chamfer on the clamps so it would still fit easily even if there were any slight miscalculations.
With this file you will be able to print Everblock 2X2 cap, with name, cut in half with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Everblock 2X2 cap, with name, cut in half.