Extended Door - Eibos Filament Dryer (Easdry)

thingiverse

An Extended Door for the Eibos Filament Dryer (aka Easdry) to accommodate wide spools such as Fiberlogy spools. The original door can use up to ~75mm spools but this door should allow you to use spools with width up to ~90mm. This print is separated into 2 pieces, the Door and the Latch (A and B respectively) which is attached by 2 M3 Flathead screws. If you have Button or Socket screws included is a Latch better suited for those screw types. Length of screw is unimportant. Your printer will need a build area about the size of an Ender 3 (220x220) to accommodate the door which is ~218.5x218.5. Be sure to print this out of something heat resistant enough to not warp and lose it's shape. The pictured door is ABS, but if your setup can't handle ABS without major warping I'd suggest something like PETG. Print with supports everywhere and use support blockers in the lanyard hole near the latch area to avoid frustrating support removal. The latch itself should be printed sideways(tallest vertically) so the latch won't break along the layer lines.