Extended Under Desk Laptop Mount with Screws

thingiverse

I like the mount by VariablePenguin, but my laptop isn't straight all the way to the edge. It starts going up couple cm before. This version is longer, so that it can hold the laptop better. I've also made screw holes to mount it, instead of gluing.Or do both :-) The holes are 11 mm wide, then 5 mm before the end shrink to 8 mm. You can find here the original version with screw holes, too. Another variant is with cable handles. It can hold up to 10-11 mm cables.Please use supports and brim to print it and make sure you block supports in the screw holes. This can be done e.g. in Cura. Finally it's oriented horizontally for printing to make it stronger. I'm the beginner these days in 3D printing. If you believe it should be printed in a different position, please comment. Please note that this part hasn't been tested in any way. Please use it only if you're confident that it will hold your laptop.