Extruder feeder assist for Ender 3 (Pro)

thingiverse

# Ender 3 (Pro) Extrusion feeder assist This assist is mainly meant for Lack enclosures, that have their filament spool holders installed on top and the filament coming through the top in a sharp angle. This print is meant for the Creality Ender 3 (Pro) stock extruder assembly. # Needed parts You are going to need a bearing to fit onto the feeder assist. I used "608 ZZ ABEC-5 Ceramic" from Biltema, but anything with similar dimensions (8 x 22 x 7 mm) should do just fine. # Assembly Slide the wheel onto the bearing (tight fit, use a rubber hammer or similar) Install the bearing and the wheel into the tap mount in the base (again, use a rubber hammer) # Installation Remove the two z-axis screws attached to the acme nut, slide the extrusion feeder assist into place, and screw the screws back. Happy printing !