EZstruder adapter for Printrbot+

thingiverse

Adapter to mount the direct drive EZstruder (from SeeMeCNC) to the Printrbot+, allowing use of 1.75 mm filament. With slight modification, the EZstruder can use the Ubis hot end. No modification to the Printrbot is required. Instructions This piece was created in TinkerCad. It is the first version, so consider the holes as pilot holes and open them up per your choice of fasteners, If using the Ubis hotend, the EZstruder will require a little dremel-type work to accomodate the Ubis's chamfered slot. The position of the hotend relative to the carriage has changed, so carefully adjust all endstops accordingly.