F series truck water bottle holder

thingiverse

I created an extra cup or water bottle holder for my f250. A family member has a water bottle (hydro flask) that is very tall and I didn't like it in the console because it got in the way of the climate controls. This fits in the right side pocket of the console and moves it out of the way. My truck is a 2021. You should measure to ensure this will fit your truck before printing. There are two parts, the pocket insert and the cup holder. I printed them separately, then expoxied them together. There is a groove on the bottom of the cup holder so it perfectly aligns on the pocket insert (not too close or far). Print the cup with supports for that groove, 15% on the supports is plenty. Print the pocket insert on a raft and use supports (the bottom is not perfect 90 degree due to the angle of the pocket on the truck). Print both parts 100% infill. I used pla, but if I have durability issues I'll print in petg. You could start there if you wish. Additionally, I printed and epoxied 90 degree support brackets between the outside of pocket insert and under the cup for additional weight support and stability while driving. I brushed a little bit of flex seal on the complete underside of the pocket insert to keep it from sliding while driving.