F1-Style rear wing v2

prusaprinters

<p>Design changes:</p> <ul> <li>Lighter base connector</li> </ul> <p>*Thinner end-plates</p> <ul> <li>Fewer and bigger airfoils</li> <li>Now with two wing designs</li> <li>Swept wings</li> </ul> <p>Files included are:</p> <ul> <li>Frangible base mount</li> <li>Low drag profile wing</li> <li>Regular profile wing</li> </ul> <p>Connecting the wing halves:</p> <p>To connect both halves of the wing together, A rectangular plastic piece should be inserted in the slots where the middle sections meet. Depth of each slot is 15mm. Just measure the height and width of the slot entry and print a rectangular piece that fits. Use some drops of glue to hold full wing together</p> <p>Fasteners required:</p> <ul> <li>4x M4x16 screws</li> <li>4x M4 nuts.</li> <li>8x M4 washers (optional)</li> </ul> <p>Wearable safety precaution:</p> <p>The base mount is made up of a thin strut design. The middle intersection should get filed down such in the event of an accident, the base can break under tension.</p> Category: Vehicles