Faceplate for DDS Signal Generator for SSB6.1 Project

thingiverse

This is my attempt to make a faceplate for the SSB6.1 Ham radio kit. V1 is a very basic plate with holes for front mounting screws. Could easily be adapted to your own custom case. V2 is a more finished look and a step closer to my goal of making a full case. I've made the mounting holes smaller to hopefully be able to use M3 screws through the rear threaded directly into the hole. If this doesn't work well I will probably add a slot to insert a captured nut and beef up the support holes. I've also added some support structure between the keypad buttons, this may be unnecessary now that i've add the side walls. There is very little information out there regarding a case for the SSB6.1 kit so my goal is to build a fully 3D Printable case, starting with the faceplate. Check back later for more.... This is the DDS I'm using: https://www.ebay.com/itm/DDS-Signal-Generator-0-55MHz-for-Digital-HAM-Radio-SSB6-1-Transceiver-VFO-SSB-/221964887452