Faceplate for LCD12864 Case

thingiverse

This is the faceplate for my LCD12864 Case ( https://www.thingiverse.com/thing:2330600 ). This thing is actually not ready to be shared in my opinion, but I got a request, so here we go. To fix this thing to the Case you need to Drill the mounting holes for the LCD in the Case through to the front of the Case. And also you need to drill holes into the faceplate, to match the holes in the Case. Then you can either use the same type of screws used to mount the LCD, or use screws that are long enough to go right through the case and mount faceplate and lcd using screw and nut. The cutouts for the speaker, dial knob and reset button are one layer thick and can easily be cutout using a sharp knife. When using this faceplate the large dial knob will go too deep on the shaft and scrape the surface. To prevent this just put two M3 nuts into the hole of the knob to prevent the shaft from going in too deep. So. There you go. Have fun with it.