Fan Blower Hood - Shroud for Geeetech I3 Prusa

thingiverse

This is my version of Fan Blower Hood (Shroud). One that fits perfectly on Geeetech i3, and that it don't obstruct air flow. Just move hotend so that wire are not in front, nor at side. Move wires to the back. There is nut, unscrew it, move, and screw back. For fixing, you need two M3x10 mm screws, with allan screw head or any similar. And, blower fan does not require any bolts and nuts - it holds by tight fit. If you don't know where to buy this excellent blower fan, here is the link: https://goo.gl/1RgWKR Print Settings Printer: Geeetech I3 B Pro Rafts: No Supports: No Resolution: 0.2 mm Infill: 20 % Notes: Print PLA at about 40 mm/s, Hotend at 210C, Bed 50-70C, Shell Thicness 0.8, Flow 100%. You are free to vary settings, since it is not critical by means of sagging and other things. If you experience problems, then you may include some support "Touching buildplate". You may use hairspray for better sticking on the bed, and/or rise up temperature up to 70C - the higher the temperature - the better it sticks. How I Designed This