Fat Spool for Cetus3D v3

thingiverse

Fat Spool for Cetus3D is an adapter for the Cetus3D spool holder that attempts to minimize the rocking seen when using wider and heavier spools on smaller holders. Can also be printed without supports. If this is your first print and you want to use less plastic, be sure you specifically disable supports in the Cetus software (it's enabled by default, find it under Print->Preferences). If you see a weird chunky wavy surface on your print, those are supports and they are totally fine (they just waste a bit of plastic for more printing stability). Just like the bed, you tear them off with the cutters once the print is done. Also be sure you re-enable supports for future prints, as not everything can be printed without supports. It has effectively a 50mm diameter, and with the lip is designed to work as if it was 60mm, but it doesn't get stuck on 50mm spools. It's 80mm long (wide enough for a 70mm spool) and should clip on to any standard 20mm V-Rail with ease. Tested to fit eSun, Polymaker, Boots Industries, Filaments.ca, and CreatorFuel filaments. Ahem, this is a bit silly, but if you print it in white, it looks a bit like Onigiri. :) Inspired by Spool Adapter by Redonix76: http://www.thingiverse.com/thing:2063959. Print Settings Printer: Cetus3D Rafts: Yes Supports: No Resolution: 0.4mm Nozzle, 0.3mm layers Infill: 13% Notes: Thinner layers (0.2mm or 0.15mm) with 15% infill is best.