Fatshark Fan Switch Box

thingiverse

This is my straightforward take on the FatShark Fan button. I used the KISS method to get it done quickly. The parts list is simple: * 1 - 10mm push button * 1 - balance plug matching my battery type * 1 - short piece of wire for the positive connection * Hot Glue to hold everything in place It's not a fancy design, but it works exactly as intended. I considered adding a tiny timer, but decided against it. A simple push button does the job just fine. It clears the fog and lets go quickly, without wasting 8-10 minutes. This project is meant to complement the Faceplate Fat Shark Attitude V2 with Fan by MRracequad, which was published on December 30, 2015. Print Settings: Printer: Davinci 1.0a Modded Repetier .92 Rafts: No Supports: No Resolution: 0.2mm Infill: 100%