Female Necromancer Miniature (28mm scale)

thingiverse

This is a 28mm scale rpg miniature that I designed using the [Desktophero](https://www.facebook.com/desktophero3D/) beta. She is a human necromancer holding a skull and a book. I recommend printing on her back an then gluing her to the included base. If you do this, I recommend using the "support interface" setting in Cura with a support interface density of 70% or less in order to make the supports easier to remove from her cape. And do take care to avoid snapping her arm off, as it will be weakened due to being vertical. Alternately, you could probably get good results by printing her upright. The print in the photo was done on a Monoprice Mini Delta at .05mm layer height.