Fender Eliminator for BMW S1000R

thingiverse

This is a fender eliminator designed on a 2019 BMW S1000R (likely will fit all years). Remove the rubber grommets from the stock fender and reuse them with this print. This will use the stock turn signals and license plate light socket. I replaced the halogen bulb (HOT HOT HOT) with an LED from eBay that is cool to the touch. Print with PETG and high infill. No supports needed. V2.4_ANGLE - license plate tilted 45 degrees, also added 6mm holes to install waterproof button LED's from Amazon. This will replace stock bulb. Look for amazon B077Z6WQ6Q V2.5_ANGLE - has a 40mm wedge to reinforce the angled plate mount UPDATE June 15 2020 - I have about 800 miles on my bike since installing V2.4 - no issues so far. Holding up well (with 40% infill PLA+). Was planning to print with PETG, but so far no reason.