FGC6 and FGC6FA UNW Magazine Catch Bar

prusaprinters

<p>(I would not use this part anymore. the lower have been updated, and can manually be updated to fix this issue)<br><br><br>I don’t know why I did not see this before. but I have noticed with the stock FGC9 magazine catch bar that the mag is a bit to hi up. were by the nozzle is pocking in the rubber casket of the WE magazine. you can check this for your self by slowly levin the bolt forward with the mag installed and look if this is also the case with your build.</p><p>if not then I would not boter with this part. since it could give you a worse air seal..<br>but on the upside it should remove some friction on the bolt.</p><p>if this one is a bit to low for you then you could just remove a bit of material from a stock FGC9 Magazine Catch Bar. so it can be custom fitted.</p><p>link to the official website (when it’s done)<br>https://www.untangleart.com/unw-fgc/</p>