Fidget Spinner - Hoverboard / swagway

prusaprinters

<p>Things needed:</p> <p>Board (qty 1) - either board will work the revised board is a little longer and has a snugger fit on the axle</p> <p>Axle (qty 2)</p> <p>608 bearings (qty 3)</p> <p>Rev 2: I tightened up the center bearing hole clearance. The bearing fit gets a bit loose after breaking it in. will make it a bit more difficult to assemblebut overtime I think it will last longer.</p> <ul> <li>Made 1 Tri version you'll need another bearing and 1 more axle</li> <li>Designed a skateboard version: <a href="https://www.thingiverse.com/thing:2310966">http://www.thingiverse.com/thing:2310966</a></li> </ul> <p>added thumb pads</p> <p>-revised axel to make abit shorter and made bearing fit a little looser some bearings were very tight fits</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Wanhao</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>Wanhao Duplicator i3 V2</p></div> <p><strong>Rafts:</strong></p> <p>Yes</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.15</p></div> <p><strong>Infill:</strong></p> <p>100</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Printed in PLA (210 nozzle 65 bed temps)</p> probably get by with 50%infill but I like the spinners solid. axles printed vertically might be a bit stronger printed horizontal but they would probably need supports. <p>I'll try one with 50% and .2 resolution to cut print time down</p> </div></p></p> Category: Toys & Games