Fiesta ST MK7 Hole Cover

thingiverse

This piece is a cover for the pointless hole above the seat heating buttons in the Fiesta ST MK7. It was inspired by the cover put into the Fiesta ST200 which I think does not really fit to the car, because of its brushed metal look. Simply print out both pieces, stick them together and glue them. They should just perfectly fit into the hole. The tolerances in this model are quiet high due to my low-cost printer model. If you need a tighter spacing feel free to pm me. I will try to soon upload .step files also to make customizing easier. EDIT: Now added *.igs files for easier customization. Print Settings Printer: CTC Bizer Rafts: Doesn't Matter Supports: No Resolution: 0.3 Infill: 100% Notes: For material I chose FormFutura Titan X in grey and Apollo X in red. Post-Printing Because I didn't like to have the 3D printing lines in the final piece I decided to sandpaper it (120,500,2000), then post process both pieces with XTC 3D, then sandpaper again and finally recolor it. I found that a mixture of 10% RAL 9005 and 90% RAL 9021 colors (both with a mat finish) was fiting quiet well. If you don't like to mix colors you can also use just RAL 9021 only, but it is slightly too bright. If anyone has the original color of the plastic below feel free to comment it. For the ST logo is used a RAL 3002 ferrari-red with a glossy finish.