Filament Color Palette

prusaprinters

<p>This is a hanger you can hang chips from to look at what color is best for your next print! The only thing you will need is a leftover piece of filament to push in the holes.&nbsp;Here is how to assemble it:<br>1. Print a least all the parts inside of the folder named “Important parts” just like the print settings (below) tell you to.<br>2. Grab a piece of useless leftover filament, <strong>must be 1.75mm filament</strong> (I used around 25 cm length) and stick both ends into the holes in the sides of the part named “Filament Color Palette Insert.”<br>3. Grab both knob 1 and knob 2 and screw them in the holes on the top and bottom of the insert piece tightly, so the leftover filament can't come out.&nbsp;<br>4. Loosen one of the knobs, remove the filament, and put the chip on the filament. Then repeat step 2 and 3.<br><br><strong>Print instructions</strong><br>Your print speed needs to be or be lower than <strong>10 quality.</strong><br>You need tp print everything on the side they are when you have downloaded it.<strong> Else they won't fit right.&nbsp;</strong><br>An infill of 15% is fine.<br>You will not need supports, except for the wall hanger.<br>No brim is needed if you have a decent bed adhesion.&nbsp;<br>Prints fine with PLA, but you can use whatever you want.<br><br>Happy printing!<br><br>Please check out my other stuff at my account!<br><a href="https://www.printables.com/social/243307-klm1318/about">https://www.printables.com/social/243307-klm1318/about</a></p>