Filament Dry Box

thingiverse

Various components for a drybox that employs a drain pipe as the spool holder are required. The following items need to be sourced: * One sealed box with a capacity of approximately 17L, sufficient to hold four spools * Printed parts * A drain pipe * A PTFE tube * A PTFE tube fitting * Twelve M3x10+ screws accompanied by nuts Printed components that must be fabricated include: * Three seals in 80/85A TPU or TPE * Two inside roller holders * Two outside plates * One outside fitting holder * One inside plate The assembly of the roller holder should follow this sequence: Outside plate, seal, drybox wall, and inside roller holder. For the filament output, the following sequence is recommended: Outside fitting holder, seal, drybox wall, and inside plate. To maintain a dry environment within the drybox, an Eva-dry 3xx series device should be utilized.