Filament feed drive guide for Wanhao Duplicator 4S(with 2mm hole)

thingiverse

Operating and Adjusting the Filament Feed Drive on Your Wanhao Duplicator 4S with a 2mm Hole First, make sure your printer is turned off. Locate the filament feed drive, which is usually situated near the extruder. Take note of the existing setup as you will need to refer back to it later. To begin, remove any loose debris or old filament from the feed drive and surrounding area. This ensures a smooth process and prevents any potential problems down the line. Next, locate your new 2mm hole nozzle. Ensure it is securely seated in place before proceeding. Now, insert the new filament into the feed drive. Hold it firmly in place with one hand while using the other to guide the filament through the machine's mechanism. Be careful not to touch any moving parts as this could cause damage or injury. As you continue to push the filament through, pay close attention to how smoothly it feeds into the printer. If there are any issues, such as jamming or resistance, stop immediately and troubleshoot the problem before continuing. Once the filament is successfully inserted, reconnect your printer to the power source and turn it on. Allow a few minutes for the machine to heat up and calibrate itself. This may take several cycles, depending on how long it has been since you last used the printer. Now that your printer is online and ready to go, you can start printing with confidence. Remember to check your filament regularly for any signs of wear or damage, as this could impact print quality over time.