Filament Filter & Feeder for CR10S-Pro

thingiverse

*DO NOT USE* The CR-10S Pro has several points where filament tends to flake or dust up. So using several plans from other designers I mashed them up into a single print to decrease the entry angle for filament feeding into the runout sensor as well as putting a filter can at the top to clean the filament as it enters the path to the machine. After printing and testing the arms to hold the bracket in place on the sensor block allowed it to sag and wiggle as the filament would pull through. When the filament would retract during a print and then extrude it caused shift delays and problems with the print. The next model will have a full surround with less friction routing (possible bearing) and additional supports to keep it from bending.