Filament Guide for an Enclosure with a 1/8th Inch (3mm) Whiteboard Roof-Top

thingiverse

When modding my printer to a direct drive extruder, I found it would be better to feed the filament through the roof-top of my custom built enclosure. I don't have an Ikea Lack enclosure, but I liked this design, and my enclosure has a 1/8 inch (3mm) whiteboard roof-top, so I remixed this design to fit. I also made the filament exit just as smooth as the entrance, and it is still able to be tightened like a normal nut (tightening by hand is tight enough though, in my opinion). There is a 3mm filament path throughout both pieces, and when they are screwed together around the 3mm whiteboard, they meet to form a seamless pathway. You need to drill a 25/64 (10mm) hole for the top piece to fit into, then screw on the smoothed nut. I hope this can help anyone with the same sized enclosure roof-top.