Filament guide for anycubic kobra max

thingiverse

Hi all, For all of you using an ANYBOX V2 (https://3d-druck-vorlagen.de/anleitung-filament-box-selber-bauen-die-anybox-v2/) or another PTFE guided filament feeding. I was a worried that the PTFE tube makes a huge impact after every retract. This cannot go well for long. And after my filament sensor was getting malfunctioning, I knew that there is somethig to do. So i made this little addon. It can be screwed right over the sensor using the present screws. The outhermost screw has to be replaced by a longer one. Now the guide is holding back the tube and no longer the sensor. The hole is about 10mm deep, so retractions up to this distance are no problem. The edge is also chamfered, so the tube will find its way in. The smaller hole might be a litte to small, so you might have to widen it with a drill.