Filament Guide Improved for the PP3DP UP! Plus Printer

thingiverse

As you can see in my profile, I do not use the standard spool holder (I made one myself under my table that can hold up to 10 spools). I had problems with the standard filament guide because my filament goes diagonally from the table to the printer. Sometimes the filament went out of the guide, even with this version of "outsider" (http://www.thingiverse.com/outsider/overview) that I liked a lot: http://www.thingiverse.com/thing:65751 So I decided to modify it a little bit, in order to make sure the fillament doesn't go out of the guide if pulling in a diagonal direction. Instructions The are two guides for the filament, you may choose the one you like the most: The inner one is closed, so you have to put the filament through the guide before extruding. The other one is opened, so you can put the filament after extruding, but it has a security top to stop the tube and it will not go out of the guide.