Filament guide system for enclosure

thingiverse

I remixed these filament guides for 608 bearings. I originally downloaded the 'Ender 3 filament guide' by Holspeed for my ender 3 and thought these remixes would help with management inside my enclosure. I have used them inside on the roof of my lack enclosure. You can check it out in the photo ive added. So basically i chopped the wheel end off and stuck a simple plate there with 4 screw holes instead. I made a wheel. Partly just for fun but also because i thought the ribs on the wheel might grip a bit better. Then i flipped the design on top of itself so that it would hold the filament in place if the line became slack. At least thats the theory. ...and thats about it.