Filament rod brackets for vertical mounting on table legs

thingiverse

This bracket setup is made to go on the legs of a table based on a 2x4 homebuilt table. The filament will protrude from under the table and it will accomodate up to a 1 inch rod which will easily lift out for easy filament replacements. The brackets are 1 inch in thickness and 4 inches in height at the back tapering to 2 inch at the front. Each side has 1/2 inch of area for the rod to rest in. The top and bottom side have 1/4 inch holes for secure mounting to the wooden legs of the table. I used the part to predrill the holes so the angle would be right and the bracket would mount flush. Placing a large flat washer under the head of the 1/4 mounting screw should make the mount VERY secure. It is a good strong bracket and should support your filament well