Filament shelf spool holder

myminifactory

Built and Designed for Joel the 3D print nerds filament shelf. It comes in 4 parts the left and right half of the shaft and register pins to help align properly. This design does not need to be glued togeather, but does to make it more solid. Register pins are also available to help with adding glue and just to help hold togeather if press fit. The shaft of the holder is also built to hold spools up to 4.5in in width or 114mm. Specific to my observations in the video the inner guard is made to hold the spools a little bit away from the shelf in order to not rub against the other spools being held on the shelf.  When assembling, you can use plyers to help press the pins if they are just too tight to press in by hand. This was built with the nominal dimensions for a 1x2 board 3/4in x 1.5in This is my first design, and can't wait to make more. :)