Filament Spool Holder - Top Mounted

thingiverse

I just made this for my CR10. If anyone else can use it, that is just a plus. This is a simple (adjustable width) top mounted filament roll holder for direct drive printers. It mounts onto any 2020/2040 top extrusion. Just use M5x10 screws and t-nuts to secure it. You cut a 1.25" (ID) PCV pipe to any desired length and adjust the mounts to fit it. Just slide the PCV pipe through the filament roll holder and set it in place. Prints with no supports. This one file is used for both sides. NOTE: If the lettering on the PCV pipe bothers you, light sanding will remove it. ;o)