Filastruder Vertical Bottle hopper deep throat version ;-)

thingiverse

Like this thing a lot, but after revising I saw that the throat was narrower at the bottle end of the tube, and decided I wanted it to be the same width all the way down - this change was made making the end just under the bottle to be a little deeper. Also widened very slightly and added a thread, to be able to use 1.5L PET water bottles instead of gasified drinks plastic bottles, as they seem to have a different thread... And finally reduced from 6 to 4 M4 screws, as I found that it was a pain to have so many, and the part started to break at the layer of the screw heads, possible from the force - with less screws less force.. the hopper only needs to be tight enough so as not to move, no need to over tighten. Is for Filabot V2.1, with the acrylic paneles. Here is link to Fusion360 gallery page, where can download any type of format that Fusion allows, if you want to redo anything ;-) https://a360.co/2JsWgHp PD always remember to cover the hole/bottle when not in use, dust is the enemy of a good extrusion!