final comb

thingiverse

Human: Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=352873 Instructions Using the following settings: tooth_margin is set to 8.25 8 teeth will be spaced evenly apart the front of the tooth will extend 1.5 units in height 0 units of clearance have been left for vertical space horizontal clearance above has been reduced to 1 unit by raised_z=0 vertical clearance above is reduced to 1 unit with raised_y = 1 unit. horizontal offset to print in this layer above is at x axis - shifted left with x - shifted amount as 68.8 units or the value of raised_x . space between teeth on each row (gap width) has been set as a non-dimensional 4 units. length across width with space for a layer is determined to be at x axis 13.7 or the actual y - length or dimension in that order of comb_y . vertical spacing up or gap for comb_z - tooth_length length or amount between these items (rows on this printer ) has been set at -1.22. height at rear end above or the tip of a rear most part to hold, will stand still at value for height with dimensions of no units in that order since all parameters must be non-dimensional when added - not less then what makes it printable