CR10S Pro Microswiss Direct Drive Mount

thingiverse

A drop in mount for the cr10s pro to convert from bowden extruder to direct drive. This has been designed to work with the microswiss extruder setup ment for the cr10. A few holes will need to be tapped as i didnt see the point in trying to 3d print such a fine thread. I havent tested this yet but am currently printing it in Polycarbonate right now, so if all goes well it should just drop straight in. **** UPDATE**** the filament guides on this did not line up properly so i designed a new one with the correct measurements. i haven't posted the new one as it fits fine but the position of the motor off the back of the gantry prevents the back plate from hitting the end stop. whilst i could have just added an extension to hit the end stop it would have meant losing 6mm of build space which i wasn't happy with. i will leave this on thingiverse in case someone wants to rework it but note, as it is it will not work. ****UPDATE**** I've updated the filament guide to line up with the hotend. this will still cause a problem with the stepper motor hitting the frame of the printer stopping it from pressing the end stop switch, but if you change to a low profile stepper motor like i have it clear the frame just fine.