Fixture Block

grabcad

Mass: 546.67 grams Volume: 202471.08 cubic millimetersSurface area: 33687.94 square millimetersExplanation: I started by creating a rough sketch of the model from the front view. Then I extruded it the with the right dimensions. After that, I added the cylinder shape onto the 'overhang'. Then, I made a cut from the top down to the base on the right hand side of the model (from the right view). After this I cut out the half-circle (the cut is actually a full circle) cut on the angled portion of the model. The last two things were the little corner trim on the bottom right (from top view) which was a simple triangle cut, and then the 2 filleted holes and single slot between them in the base.