Flash Bolt Magnetic Chest Logo

thingiverse

Update: I just noticed the STL of the bolt is upside down. Flip that 180 before you print. Otherwise the show side will have overhang issues possibly. I modified SKETCHPUNK's version of this awesome logo chest piece to fit standard size magnets (8mm diameter, 2mm height). I also removed the 2 holes in the plate and bolt that were not used. All the credit to Sketchpunk for a great design. Printed with ABS @ .2 resolution and 30% infill. It wouldn't hurt it to go down to 15-20% either. No enclosure needed, but I did turn off the fans on my Ender 3 and added a wide brim. My surface turned out a little bumpy, but I will most likely give it a vapor bath and smooth it all out. I would scale it up to 102-104% next time I make this because for some reason, my 8mm holes turned into 7.5mm holes. So some post production drilling was needed. ENJOY!