Flash Diffuser for Meike MK320 with small lenses

prusaprinters

<p>This diffuser was designed specifically for use with the Meike MK320 flash and very short macro lenses. It snaps in place without any additional shenanigans to keep it in place - remove by pinching the top &amp; bottom where this diffuser slides over the flash and wiggle side to side.</p><p>&nbsp;</p><p>This part was designed to be printed without supports and with a 0.6mm nozzle (0.4 might need arachne or some tweaking to print settings).</p><p>Print flash down (narrow end) - brim recommended - no supports needed.</p><p>Once printed <strong>line the inside with aluminum tape</strong> - but only the parts which need to be reflective! So don't go lining the part you need to slide over the flash head with tape or it might be too tight.</p><p>Use any diffuser material of your choice, a white plastic bag, white paper towel, thin packing material, etc. and secure with a large rubber band such as the kind you'll find holding bundles of produce.&nbsp;</p>