Flash Forge Creator Pro X-Carriage

thingiverse

Hello Thingiverse, I was having issues with my X-Carriage binding because the stock design is too large, causing the bearings to fail prematurely. I redesigned the carriage In a way that allows for a slight amount of adjustment on the bearing spacing, this way they are all positioned perfectly and my carriage no longer binds. I replaced all the bearings in the X & Y axis with these bearings from MISUMI (LMU-N8), Note that they are longer than the stock bearings but they will fit fine in the stock y-axis carriages. These run about 5$ a piece. This also requires (6) M2 - 12 mm lg. Socket head cap screws, & (6) M2 Nuts. DO NOT BUY THE CHEAPER BEARINGS ON AMAZON, I tried those first and they were such poor quality they were unusable. I hope this model helps out other FFCP users having the same issue, Happy Printing!