Flashforge Adventurer 3 Dual fan duct, led soft box, plus original clips & air duct

thingiverse

This is a remix of a remix of a (kind of) remix. Previous ones did not have the back clips that the original Flashforge one had to keep the air duct (and things above it) in place, nor did they have the original's inner air pipe. This model has both. I tested it - went in nicely and the PLA test tower looks good. Sliced with Cura: 245C / 100C for ABS. No fan. Requires supports (touching build plate only). With 0.2 layer height I put 0.2 space between supports and the print - I think this should be the minimum unless your settings and filament are truly dialed in. 1 mm of support roof gave it a nice even finish. Be careful not to break the small back clips while removing the support. I also tried slicing this with Flashforge slicer, didn't give as nice of a print after supports were removed - maybe you can make it smoother.