Flashforge Creator Pro Power Supply (Mean Well NES-350-24) Beefcake Fan Shroud Upgrade
thingiverse
NOTE: The printer will need to be lifted up about 0.5" off the supporting surface. This mod will not leave any room for airflow with the stock feet (e.i. print upgraded feet or put some 0.5" blocks under the stock rubber support feet). This fan shroud allows the installation of two 92mm fans in a Mean Well NES-350-24 power supply. My printer is installed in an enclosure with elevated ambient air temperature so I needed to increase the forced convection through my printer's power supply. These fans (ARCTIC F9 TC - 92 mm Standard Low Noise Temperature Controlled Case Fan) are also much quieter than the single small fan that comes stock on the power supply.
With this file you will be able to print Flashforge Creator Pro Power Supply (Mean Well NES-350-24) Beefcake Fan Shroud Upgrade with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Flashforge Creator Pro Power Supply (Mean Well NES-350-24) Beefcake Fan Shroud Upgrade.