FlashForge Guider II blanking pieces

grabcad

This piece blocks off the holes in the back of a Guider II (& S) printer. We found the rear spool holder too hard to reach and not really all that smooth. So created a filament holder - see other models, and then blocked off the holes for the old holder. This becomes even more essential when printing ASA/ABS etc to cut down on the amount of fumes getting out.As the rear panel of the Guider II is metal the blanking pieces make use of 5.5mm square x 2.5mm high magnets.There will be another part to this which is the fume extraction hood that goes over the Flashforge carbon filter - separate model soon.UPDATE: Added a V2 of the design which allows for a temperature probe cable to pass through.