flat nose Rotorx Atom 3/4" Canopy

thingiverse

this is a small variation on DaltzisSalt's original version- I was having trouble getting a good nose with the contours in the original model, so I chopped a little bit off leaving a good flat surface to build up from. This lets me print without using a raft and I got a much cleaner result. I printed in petg with 2 perimeters 4 bottom and top layers 10% infill and it came out 13.7 grams. The original polycarbonate canopy from rotorx is around 9 grams. 1/5/19- added a new version that is based on building my atom. using the hglrc zeus, it covers the rear canopy mounting holes. I was trying to use 3mm standoffs as nuts on the front 2 holes.. but they were a pita to put in and remove, so built up the area around the holes to just thread into. Additionally I have added cutouts on the side for the usb fc connector and to get to the boot button on the zeus. I have another cutout on the side since I was going to use a runcam mini split 2, but am having trouble with getting the white splashscreen on it, so scratching that I modifed the cam mount to fit the larger swift mini 2 johnnyfpv version. I also made the flats for the screws for the camera mount larger so I could use a 2mm washer so the screw head did'nt pull through the hole. 1/21/19- Dalton shared his original fusion 360 project with me so I took the changes from 1/5 and applied it to that and made a few more changes- the big one was since I am usig a dipole antenna, I added side supports and holes for a ziptie to tie it in place- no way it will break off now in a crash.