Fleshlight large end stand

thingiverse

I had printed a fan attachment for the small end of the FL, but thought that the horizontal design could lead to pooling of water in the various grooves, so I wanted something vertical. I modified steamgineer's cap ring into table so the FL sits up off the surface and air can flow through the case and the FL to assist in drying. Picture shows the fan attachment from https://www.thingiverse.com/thing:4157501, the FL case, and this design. I hadn't received my fan yet. I have since received a fan that was 1800 rpms. While you can feel slight airflow through the case/FL its not a lot. It may be enough for drying but may try to find a higher rpm fan. There is a small glitch near one of the legs that doesn't effect anything other than maybe add a little time to printing.