Flipper Zero minimal TPU case

thingiverse

Made a flipper case by combining the TPU case (https://www.printables.com/model/237502) with the faceplate from https://www.printables.com/model/351398), made with the intention of putting a qi wireless pad in the bottom of it. there is a very thin couple layers over the buttons, making them less "clicky" and more "thocky". (similar to the electrical tape "mod" popping up on reddit). I didn't notice any reduction in signal strength. I also removed the access to the micro SD card. This case is made for very flexible TPU only.. and even still, it's an almost impossible squeeze to get it in through the front window. this will also eat through a bunch of filament just in support material. It was easier to rip it off my flipper than it would have been to take it off the hard way, so printer beware!