Flipsky dual VESC 6.6 case / skateboard top mount

thingiverse

This is a top mount case for the Flipsky dual VESC 6.6. The esc sits face up with enough room underneath for a small amount of air flow - though there's no vents on the case yet. The power leads face forward toward my foot and I was able to easily route them up through the foot strap to the battery pack mounted in the middle of the board. Motor wires have to make a 90 degree turn to exit the rear of the case but there's enough room for them to comfortably make that turn without too much stress on them. I secured the lid to the body with four #4 x 7/8" flat head wood screws. This is still a bit of a work in progress - I didn't include the Bluetooth module in my build and so didn't make room for it in the case. I also plan to add a 5V output for accessories like hard wired head and tail lights. I printed this in PETG for durability and better heat tolerance than PLA. If it doesn't hold up I'll need to switch to ABS.