Flir Exx Exxbx Tripod Mount

thingiverse

This is a Tripod Mount for the Flir Exx(bx) camera series. There have been complaints that the original tripod adapter accessory was both very expensive ($50) and yet not very stable. Therefore created a cheap and stable version that anyone can 3D print, that fit multiple tripods, including the very common Manfrotto 200PL-14 mount plate. The adapter has a thumbscrew wheel to secure it to the thermal imager, as well as a Velcro-strap to further stabilize it to the handle of the imager. It uses 2pcs 3/8 -> 1/4 UNC adapters to be able to provide a metal thread for the tripods screw. The Thumbwheel has to be threaded with a M5 thread. [REQUIRED HARDWARE] 1 pcs M5x14 hex socket screw (insex) 2 pcs <a href="https://www.banggood.com/Female-14-to-Male-38-Convert-Screw-Adapter-for-Tripod-Monopod-Ballhead-DSLR-SLR-Camera-p-1202193.html?p=DZ1112667138201407XF" rel="nofollow">3/8 -> 1/4 UNC adapter</a> 1 pcs <a href="https://www.banggood.com/10PCS-26cm-Eachine-Lipo-Battery-Tie-Down-Strap-p-1137622.html?p=DZ1112667138201407XF" rel="nofollow">Velcro-strap (20 mm wide, ~155mm loops, ~80mm hooks)</a> Optionally, can place 1mm soft one-sided foam tape at the top surface and handle surface to further minimize risk of wear. [DONATIONS] If you find that the item improve your daily life, consider supporting the designer by sending a tip. <a href="http://www.thingiverse.com/Pawpawpaw85/about" rel="nofollow"> Click "TIP DESIGNER" here.</a>