Floating Snowflake Earrings

thingiverse

This is pretty much the ornament but as an earring. I wanted to share it for those who don't want to mess with the files. I had to print these earrings one at a time because my extruder hit one of the snowflakes when I tried printing two at once. If I could figure out where the extruder was going, I'd try printing two at once and love to hear if someone figures it out. Both prints require a pause before layer 6 (10 layers total) and you have to print the snowflake before the border. So the order is: Start the snowflake print and add a piece of tulle before layer 6. When the print is done, carefully take it off. Then start the border print. When it pauses, add the tulle with the snowflake on it. Line it up as best you can and tape it down. Now start up the print and make sure the extruder doesn't hit the snowflake. The print finishes and you're done! Repeat for the other earring. The other earring designs can be found here: https://www.thingiverse.com/thing:3261824 This has been added to my posting on Etsy. If you are interested, check it out at https://www.etsy.com/shop/MasterofNoneBoutique