Floating tablet wall mount with charger support

prusaprinters

<p>A wallmount for tablets thats invisible when viewed straight on, holding the tablet 5mm from the wall. Designed for these adhesive strips: <a href="https://www.amazon.de/dp/B000KJOC78?tag=thingiverse09-20">tesa Powerstrips Large</a>. Should fit almost any tablet and is easily removable.</p> <p>The wall plate for chargers is meant for chargers that fit inside a standard 60mm junction box as commonly found in Europe, like this: <a href="https://www.amazon.de/dp/B082B7RZ5H?tag=thingiverse09-20">Smart things s24L/A sCharge 12W</a>. The other wallplate has 4mm holes placed 70mm apart for courntersink screws. Its important for both plates that the screws do not protrude over the surface, as they would otherwise contact and scratch the tablet.</p> <p>Make sure to clean the surfaces well before applying the adhesive strips. Apply the strips to the tablet plate and place the pull tabs for removal over the holes. To align the tablet plate I recommend using something parallel, like a ruler. Route the charging cable through the grooves, then slide the tablet mound down onto the wall plate.</p> <p>To remove the tablet, just slide it upward and take it off the wall. To remove the strips, pull the tabs through the hole, carefully use pliers if necessary, until the strip is completely released.</p> Category: Tablet