Floor stand for small speakers

thingiverse

This is a floor stand for smaller speakers that has a tilt-back angle of 15 degrees. I made this just to raise the speaker off the floor to look a bit more tidy. The speaker platform has a little lip to stop the speaker slipping off the back. The height of the speaker from the base of the stand is 132mm at the back and 155mm at the front. The speaker platform is 100mm square. The base is 145mm wide, 130mm deep. Print Settings Printer Brand: Up! Printer: Up Plus2 Rafts: Yes Supports: No Resolution: 0.15 Infill: 10% Notes: When printed on its back it will print without any supports and the column is hollow to minimise on material consumption. I printed in ABS on my UP! Box and although I got no warping the raft was tugged on a little. The print area required is 155mm x 145mm with a height of 130mm.